HTsafer DN/OD 125
This is how house drainage works today
Quick processing, secure sealing, optimal noise performance,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Easy and quick processing
- Patented triple sealing lip
- Replaceable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame-retardant B1
- Approved with the most common fire protection collars from various renowned manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also suitable for central vacuum systems
Application:
Drainage inside buildings as a wastewater pipe, rainwater pipe, ventilation pipe
(see also application areas: DIN 1986-4).
This pipe system can be very easily installed, mounted, and laid through push connections with sockets, into the beveled pipe end (spigot end).
During installation, the pipe is pulled out one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it is important to ensure that wastewater does not back up or solid particles accumulate, which could clog the pipe system.
A minimum gradient of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3-degree gradient) to the main pipe.
The diameter of the HT drainage pipe system should neither be too small nor too large. Too large diameters reduce the sufficient floating depth of solid particles. Deposits and blockages could result. Too small pipe diameters bring the risk that the pipe could fill completely. The resulting air blockage can siphon off the odor trap. Odors from the downpipes could rise from the drain into living areas.
HT pipes can be cut to any desired length with a metal or fine saw. A miter box can be used. Saw edges should be chamfered to achieve a proper connection between the HT pipe and subsequent parts. Burrs formed inside the pipe should also be removed to prevent damage to seals and the accumulation of deposits.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application ranges: -20° to 90°
- high chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- high abrasion resistance of polypropylene, thus longevity and operational safety
- excellent impact resistance and toughness
- low tendency to crack formation and crack propagation
- robust behavior under mechanical stress (e.g., high-pressure cleaning)
- smooth surfaces, optimal hydraulics
- no incrustation, deposits cannot set
- self-cleaning, thus large maintenance intervals
