HTsafer DN/OD 110
This is how house drainage works today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Simple and quick processing
- Patented 3-fold sealing lip
- Interchangeable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame retardant B1
- Approved with the most common fire protection collars from various well-known manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also for central vacuum systems
Application:
Drainage inside buildings as sewage pipeline, rainwater pipeline, ventilation pipeline
(see also areas of use: DIN 1986-4).
This pipe system can be easily plugged, installed, assembled, and laid using socket joints into the chamfered pipe end (nozzle side).
During installation, the pipe is pulled out one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it should be noted that the wastewater does not back up or solid parts accumulate, causing the pipe system to clog.
A minimum gradient of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3 degrees gradient) to the main pipe.
The diameter of the HT drainage system should be neither too small nor too large. Too large diameters reduce the sufficient buoyancy of solids. Deposits and blockages could result. Pipes with too small diameters pose the risk of complete filling. The resulting air closure can cause the siphon to be sucked out. Odors from the waste pipes could rise from the drain into living spaces.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges should be chamfered to achieve a proper connection between the HT pipe and subsequent parts. Burrs inside the pipe should also be removed to avoid damaging seals and preventing deposits.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application ranges: -20° to 90°
- high chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- high abrasion resistance of polypropylene, thus longevity and operational safety
- excellent impact resistance and toughness
- low tendency to crack formation and propagation
- robust behavior under mechanical stress (e.g., high-pressure cleaning)
- smooth surfaces, optimal hydraulics
- no incrustation, deposits cannot settle
- self-cleaning, thus large maintenance intervals
