HTsafe DN/OD 50
This is how house drainage is done today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Easy and quick processing
- Patented triple-seal lip
- Exchangeable NBR seal
- Very good noise protection
- Proven centimeter marking
- Flame-resistant B1
- Approved with the most common fire protection collars from various well-known manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also for central vacuum systems
Application:
Drainage within buildings as sewage pipe, rainwater pipe, ventilation pipe
(see also areas of application: DIN 1986-4).
This pipe system can be easily connected, installed, mounted, and laid by means of plug connections with sockets, in the chamfered pipe end (spigot end).
When assembling, the pipe is pulled out one centimeter again after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it is important to ensure that the wastewater does not back up or that solid particles cannot accumulate and clog the pipe system.
A minimum gradient of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3-degree gradient) to the main pipe.
The diameter of the HT drainage pipe system should be neither too small nor too large. Too large diameters reduce the sufficient swimming depth of the solid particles. Deposits and blockages could be the result. Too small pipe diameters carry the risk that the pipe fills completely. The resulting air blockage can cause the odor trap to be sucked out. Odors from the downpipes could rise from the drain into living spaces.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges are to be beveled to achieve a proper connection between the HT pipe and subsequent parts. Burrs arising inside the pipe are also to be removed so that seals are not damaged and deposits do not accumulate.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application ranges: -20° to 90°
- High chemical resistance; pH 2-pH 12 (acidic-basic) stable against biogenic sulfuric acid corrosion
- High abrasion resistance of polypropylene, resulting in longevity and operational safety
- Excellent impact resistance and toughness
- Low tendency to crack formation and crack propagation
- Robust behavior under mechanical load (e.g., high-pressure flushing)
- Smooth surfaces, optimal hydraulics
- No incrustation, deposits cannot settle
- Self-cleaning, resulting in long maintenance intervals
