HTsafe DN/OD 32
This is how house drainage works today
Quick processing, secure sealing, optimal noise behavior,
- Perfect price/performance ratio
- Manufactured according to DIN EN 1451-1
- Made in Germany
- Extremely durable
- Easy and quick processing
- Patented triple sealing lip
- Interchangeable NBR seal
- Very good sound insulation
- Proven centimeter marking
- Flame-retardant B1
- Approved with the most common fire protection collars from various well-known manufacturers
- Approved with our pull-out protections up to a maximum pressure of 2.0 bar
- Also suitable for central vacuum systems
Application:
Drainage within buildings as wastewater pipe, rainwater pipe, ventilation pipe
(see also fields of application: DIN 1986-4).
This pipe system can be very easily installed, mounted, and laid using socket connections that fit into the chamfered pipe end (socket side).
During installation, the pipe is pulled out one centimeter after complete assembly to create an effective length compensation.
When laying the pipes and fittings, it is important to ensure that the wastewater does not back up or that solid particles accumulate, which could clog the pipe system.
A minimum gradient of 2 cm per meter is required. HT branches and other fittings are therefore equipped with a maximum angle of 87 degrees (3-degree gradient) to the main pipe.
The diameter of the HT drainage pipe system should be chosen neither too small nor too large. Large diameters reduce the buoyancy of the solids sufficiently. Deposits and blockages could be the result. Small pipe diameters pose the risk of the pipe filling completely. The resulting air seal can siphon off the odor trap. Odors from the downpipes could rise from the drain into living spaces.
HT pipes can be cut to any length with a metal or fine saw. A miter box can be used. Saw edges must be chamfered to achieve a proper connection between the HT pipe and subsequent parts. Burrs forming inside the pipe must also be removed to prevent damage to seals and avoid accumulation of deposits.
Material properties
Pipes and fittings made of polypropylene with the ability to withstand hot water, manufactured according to DIN EN 1451-1.
- Temperature application range: -20° to 90°
- high chemical resistance; pH 2-pH 12 (acid-base) stable against biogenic sulfuric acid corrosion
- high abrasion resistance of polypropylene, thus longevity and operational safety
- excellent impact resistance and toughness
- low tendency to crack formation and crack propagation
- robust behavior under mechanical stress (e.g., high-pressure flushing)
- smooth surfaces, optimal hydraulics
- no incrustation, deposits cannot set
- self-cleaning, thus long maintenance intervals
